ALL-ANGLE COG WRENCH

The swivel gear mechanism of the all-angle cog wrench allows the electrician to adjust the proper angle for socket placement and nut positioning in hot-stick operations.

The fiberglass pole installed parallel to the tube, attached to the handle, is responsible for stabilizing the gear head, keeping it aligned, even when rotating the pole.

The gear is complemented by a 1/2” square fitting to connect with the sockets that will operate the nuts.

The gear angle can be pre-adjusted up to 140° in relation to the pole using the two wing nuts on the head.

The gear mounting head is made of bronze alloy and the gears are made of special heat-treated steel. This versatile hardware set is installed in the RITZGLAS® tube to ensure the required safety clearance and insulation.

WARNING
This pole is mechanically sized for nut adjustment only, with a maximum torque of 2.0 daN.m (15 ft-lb).
It must be tighten with the proper torque using the flexible socket pole.